No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring DSVPN

Configuring DSVPN

Pre-configuration Tasks

Before configuring DSVPN, configure public network addresses to ensure that routes between nodes are reachable.

After DSVPN is configured, a Spoke can dynamically obtain the public network address of its peer device and establish a tunnel with the peer device to exchange data.

Configuration Procedure

Perform the following operations on the Hub and Spokes to configure DSVPN. Configuring an IPSec profile is optional. You are advised to perform this operation to protect packets against attacks because NHRP does not provide the encryption and decryption functions.

Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 142852

Downloads: 359

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next