No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the IPSec Running Status

Monitoring the IPSec Running Status

Prerequisites

All IPSec configurations are complete.

In routine maintenance, you can run the following commands in any view to check whether IPSec is functioning properly.

Procedure

  • Run the display ike sa [ remote ipv4-address ] command to check brief information about IKE SAs.
  • Run the display ike sa [ remote-id-type remote-id-type ] remote-id remote-id command to check brief information about IKE SAs based on the remote ID.
  • Run the display ike sa verbose { remote ipv4-address | connection-id connection-id | [ remote-id-type remote-id-type ] remote-id remote-id } command to check detailed information about IKE SAs.
  • Run the display ipsec sa [ brief | duration | policy policy-name [ seq-number ] | remote ipv4-address ] command to check IPSec SA information.
  • Run the display ipsec history record [ remote-address remote-address ] command to check history information about IPSec tunnels.
  • Run the display ipsec statistics [ tunnel-number ] command to check IPSec packet statistics.
  • Run the display ike statistics { v1 | v2 } command to check IKE statistics.
  • Run the display ikev2 statistics { eap | error | notify-info | packet | sa } command to check statistics on IPSec tunnels negotiated using IKEv2.
  • Run the display ipsec statistics route command to check IPSec route injection statistics.
  • Run the display ike error-info [ verbose ] [ peer remote-address ] command to check information about IPSec tunnel negotiation failures using IKE.
  • Run the display ike offline-info [ peer remote-address ] command to check information about deleted IPSec tunnels established through IKE negotiation.
Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 152382

Downloads: 369

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next