No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for L2TPv3

Application Scenarios for L2TPv3

An enterprise has branches located in different cities. The branches deploy Ethernet networks and have gateways to allow access to the IP network. To establish Layer 2 connections between the branches as well as between the headquarters and branches, L2TPv3 can be enabled on the gateways. The gateways then become L2TP Control Connection Endpoints (LCCEs) and set up L2TPv3 tunnels to transparently transmit Ethernet packets, lowering carrier network investment.

NOTE:

L2TPv3 can be used to set up point-to-point (LAC-LAC) connections, but not point-to-multipoint connections.

L2TPv3 can be used only when the devices at both end of the tunnel connect to VLANs or use AC interfaces.

Only one VLAN can be configured for an L2TPv3 tunnel.

Figure 2-4  L2TPv3 tunnel setup
Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 143170

Downloads: 361

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next