No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for DSVPN

Default Settings for DSVPN

Parameter Default Setting
NHRP domain of an interface 0
NHRP authentication Unspecified
Time interval at which a Spoke registers with the Hub 1800 seconds
Holding time of NHRP mapping entries 7200 seconds
NHRP redirect function Disabled
NHRP shortcut function Disabled
Adding dynamically registered branches to the NHRP multicast member table Unspecified
Method to process conflicting NHRP mapping entries during NHRP registration Not overridden
Referencing an IKE peer in the IPSec profile Not referenced
Referencing an IPSec proposal in the IPSec profile Not referenced
Using PFS in IPSec negotiation Unused
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 142585

Downloads: 359

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next