No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Collecting and Viewing Statistics on Tunnel Interfaces

Collecting and Viewing Statistics on Tunnel Interfaces


To check the network status or locate network faults, you can enable traffic statistics collection on tunnel interfaces and collect traffic statistics on the tunnel interfaces.


  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel interface-number

    A tunnel interface is created and the tunnel interface view is displayed.

  3. Run statistic enable { inbound | outbound }

    The traffic statistics collection is enabled on a Tunnel interface.

    By default, traffic statistics collection is disabled on a Tunnel interface.

  4. Run display interface tunnel

    The traffic statistics on tunnel interfaces is displayed.

Follow-up Procedure

Run the reset counters interface tunnel [ interface-number ] command in the user view to reset statistics on a tunnel interface to avoid interference of the original statistics.

After you reset the statistics on a specified tunnel interface, statistics information about the number of sent and received packets and the packet transmission rate are cleared. Exercise caution when you run this command.

Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 142109

Downloads: 357

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next