No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration

Checking the Configuration

Context

After you complete configuring VXLAN service access points and VXLAN tunnels, run the following commands to check the VXLAN configuration.

Procedure

  • Run the display bridge-domain [ bd-id [ brief | verbose ] ] command to view the BD configuration.
  • Run the display vxlan tunnel [ tunnel-id ] [ verbose ] command to view VXLAN tunnel information.
  • Run the display vxlan vni [ vni-id [ verbose ] ] command to view VXLAN configuration of a specified VNI or all VNIs.
  • Run the display bgp evpn routing-table command to view EVPN route information.
Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 143409

Downloads: 361

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next