No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the CCC VLL

Configuring the CCC VLL

The CCC VLL does not require signaling negotiation or exchange of control packets; therefore, it consumes few resources and is easy to configure. However, it requires manual configuration and makes network maintenance and expansion difficult. This mode applies to small-scale MPLS networks with simple topologies.

Pre-configuration Tasks

  • Enabling basic MPLS capabilities on the PE and P devices of the MPLS backbone network before configuring a local CCC connection

Procedure

  • Configure a local CCC connection.

    To create a local CCC connection, you only need to configure the inbound and outbound interfaces of the CCC connection on the PE device. Perform the following operations on the PE device:

    1. Run system-view

      The system view is displayed.

    2. Run mpls l2vpn

      MPLS L2VPN is enabled and the MPLS L2VPN view is displayed.

      Enable MPLS L2VPN on the PE device before you configure a VLL.

    3. Run quit

      Return to the system view.

    4. Run ccc ccc-connection-name interface interface-type1 interface-number1 [ raw | tagged ] out-interface interface-type2 interface-number2 [ raw | tagged ]

      A local CCC connection is created.

      The local CCC connection is bidirectional; therefore, only one connection is required.

Verifying the Configuration

After you complete configuring the CCC VLL, run the following commands to check information about the CCC connection and interfaces used by the connection.

  • Run the display vll ccc [ ccc-name | type local ] command to check information about a CCC connection.
  • Run the display l2vpn ccc-interface vc-type ccc [ down | up ] command to check information about interfaces used by the CCC connection.
Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 152937

Downloads: 369

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next