No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Resetting the Keepalive Packet Statistics on a Tunnel Interface

Resetting the Keepalive Packet Statistics on a Tunnel Interface


When you need to calculate and analyze statistics on a tunnel interface, reset the statistics to avoid interference of the original statistics.

After you reset the Keepalive packet statistics on a specified tunnel interface, statistics on the number of Keepalive probes and Keepalive reply packets are cleared.

The cleared Keepalive packet statistics cannot be restored. Exercise caution when you run the command.


  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel interface-number

    The tunnel interface view is displayed.

  3. Run reset keepalive packets count

    The Keepalive packet statistics on the tunnel interface is reset.

Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 142486

Downloads: 359

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next