No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the IKE Configuration

Verifying the IKE Configuration

Prerequisites

The IKE configurations are complete.

Procedure

  • Run the display ike identity [ name identity-name ] command to check information about an identity filter set.
  • Run the display ike peer [ brief | name peer-name ] or display ike peer [ brief | name peer-name ] ctrl-plane command to check IKE peer information.
  • Run the display ike proposal [ number proposal-number ] or display ike proposal [ number proposal-number ] ctrl-plane command to check parameters in the IKE proposal.
  • Run the display ike sa [ remote ipv4-address ] command to check brief information about IKE SAs.
  • Run the display ike sa [ remote-id-type remote-id-type ] remote-id remote-id command to check brief information about IKE SAs based on the remote ID.
  • Run the display ike sa verbose { remote ipv4-address | connection-id connection-id | [ remote-id-type remote-id-type ] remote-id remote-id } command to check detailed information about IKE SAs.
  • Run the display ike global config command to check global IKE configuration.
  • Run the display ike user-table [ number user-table-id [ user-name user-name ] ] or display ike user-table [ number user-table-id [ user-name user-name ] ] ctrl-plane command to check IKE user table information.
Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 153152

Downloads: 369

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next