No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - WLAN-AC

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the concepts, configuration procedures, and configuration examples of WLAN-AC features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Network Interconnections

Configuring Network Interconnections

To enable APs and STAs to obtain IP addresses, APs to discover the AC and go online on the AC, and STAs to access the network, configure interconnections between network devices.

The APs need to send service packets to STAs, and forward management packets and STAs' service packets the AC. When configuring network interconnections, configure the management and service packets separately.

Configuring Management Packet Exchange

Management packets between the AC and APs are transmitted only on the network between them. To ensure that the AC and APs exchange management packets properly, you need to configure correct VLANs and routes.

NOTE:

The PVIDs of network device interfaces directly connected to the APs must be set to management VLAN IDs.

Configuring Service Packet Exchange

Service packets are transmitted between the STAs and upper-layer network. Configure service packet exchange based on the forwarding mode to ensure their proper transmissions.
  • Tunnel forwarding mode:
    • Configure the AC and APs to exchange management packets but not service packets. In tunnel forwarding mode, service packets are encapsulated in CAPWAP data tunnels and forwarded by the AC to the upper-layer network.
    • Configure the AC to exchange service packets with upper-layer network devices.
  • Direct forwarding mode:

    Configure the APs to exchange service VLAN packets with the upper-layer network. In direct forwarding mode, service packets are not encapsulated in CAPWAP data tunnels. They can be forwarded directly or by the AC to the upper-layer network.

Configuring APs and STAs to Communicate with the DHCP Server

The APs and STAs must obtain IP addresses from the DHCP server; therefore, you need to configure the APs and STAs to communicate with the DHCP server.

Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100033726

Views: 38825

Downloads: 229

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next