No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - WLAN-AC

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the concepts, configuration procedures, and configuration examples of WLAN-AC features.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Uninterrupted AP Operation After CAPWAP Link Disconnection

Uninterrupted AP Operation After CAPWAP Link Disconnection

In a scenario that uses direct forwarding and AC+Fit AP architecture, the AP and AC must establish a CAWAP tunnel for control packet forwarding before a STA connects to the Internet through WLAN. When the CAPWAP tunnel is faulty, the AP cannot forward data packets, online users on the AP are forcibly disconnected from the AP, and new users cannot connect to the AP. These problems negatively affect user experience. To solve these problems, enable the AP to hold services and grant new users access permission after the CAPWAP link is disconnected.

  • Service holding upon CAPWAP link disconnection

    After the service holding function is enabled, the AP can still forward data packets when the CAPWAP tunnel is faulty. This function ensures uninterrupted data service transmission in direct forwarding mode, reducing loss for users and improving service reliability.

    Figure 4-19  Service holding upon CAPWAP link disconnection
  • User access permission after CAPWAP link disconnection

    The service holding function takes effect only for online users but not for offline users. Under normal circumstances, offline users are not allowed to go online when the CAPWAP link is broken.

    When the function that allows user access after CAPWAP link disconnection is enabled, the AP allows offline users to go online and access the network. After the broken CAPWAP link is restored, the AP forces all the STAs that have gone online during CAPWAP link disconnection to go offline. The AP then automatically reassociates with the STAs and reports information about the STAs through logs.

    NOTE:

    This function takes effect only when the WLAN uses open system authentication, pre-shared key authentication, or WPA/WPA2–PSK authentication.

    This function allows all the users that enter the correct key to go online. The STA whitelist and blacklist configured on the AC do not take effect after the CAPWAP link is broken.

    When the function that allows user access after CAPWAP link disconnection is disabled, STA association and key negotiation are performed between the AC and STA. After this function is enabled, STA authentication, association, and key negotiation are performed between the AP and STA. The different processes for association and authentication are shown in Figure 4-20.

    Figure 4-20  User access permission after CAPWAP link disconnection
NOTE:
Currently, the device supports only service holding upon CAPWAP link disconnection when it functions as the AC.
Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100033726

Views: 33625

Downloads: 207

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next