No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - WLAN-AC

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the concepts, configuration procedures, and configuration examples of WLAN-AC features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Set a Proper Interval for Sending Beacon Frames?

How Do I Set a Proper Interval for Sending Beacon Frames?

The AP sends Beacon frames at intervals, notifying a STA of the WLAN. The AP also notifies the STA that AP data will be sent to the STA based on the DTIM in Beacon frames.

When the interval at which Beacon frames are sent is set to 1000 ms, mobile device save more power. However, packets are buffered on the AP and are not sent to STAs immediately. As a result, there is a delay in sending ping packets and some packets are lost. It is recommended that the interval be set to 100 ms.

Run the beacon-interval command in the radio profile view to set the interval to 100 ms.

Updated: 2019-08-07

Document ID: EDOC1100033726

Views: 38846

Downloads: 229

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next