No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - WLAN-AC

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the concepts, configuration procedures, and configuration examples of WLAN-AC features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Parameters for an AP's Wired Interface

Configuring Parameters for an AP's Wired Interface

Context

You can configure the wired interface on a root AP to connect to the AC or configure the wired interface on an AP to deploy a Layer 2 network or directly associate with STAs.

On WDS networks, an AP wired interface can work in the following modes:

  • root mode: The wired interface that connects the root AP to the AC must work in root mode.
  • endpoint mode: When the wired interface of an AP works in endpoint mode, the AP's wired interface can directly connect to a STA or be used to deploy Layer 2 networks.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan ac

    The WLAN view is displayed.

  3. Run wired-port-profile name profile-name

    An AP wired port profile is created and the AP wired port profile view is displayed.

    By default, the system provides the AP wired port profile default.

  4. Set parameters for an AP wired interface.

    • Configure a wired interface to work in root mode.
      1. Run the mode root command to configure an AP's wired interface to work in root mode.

        By default, the GigabitEthernet interface of a common AP works in root mode, the Ethernet interface in endpoint mode, and the Eth-trunk interface in root mode.

    • Configure a wired interface to work in endpoint mode.
      1. Run the mode endpoint command to configure an AP's wired interface to work in endpoint mode.

        By default, the GigabitEthernet interface of a common AP works in root mode, the Ethernet interface in endpoint mode, and the Eth-trunk interface in root mode.

      2. Run the vlan pvid vlan-id command to configure the PVID of an AP's wired interface.

        By default, no PVID is configured for an AP wired interface.

      3. Run the vlan { tagged | untagged } { vlan-id1 [ to vlan-id2 ] } &<1-10> command to add an AP's wired interface to VLANs.

        By default, an AP wired interface is added to VLAN 1 in untagged mode.

        NOTE:

        An AP's wired interface can be added to a maximum of 256 VLANs.

      4. Run the user-isolate { all | l2 } command to enable user isolation on an AP's wired interface.

        By default, user isolation is disabled on an AP's wired interface.

Follow-up Procedure

Run the wired-port-profile profile-name interface-type interface-number command in the AP group view or AP view to bind the specified AP wired port profile to the AP's wired interface.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100033726

Views: 34049

Downloads: 211

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next