No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - WLAN-AC

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the concepts, configuration procedures, and configuration examples of WLAN-AC features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for WDS

Application Scenarios for WDS

In WDS application, APs can be deployed in the hand-in-hand or back-to-back mode.

Hand-in-Hand WDS Networking

As shown in Figure 8-5, AP1 is a single-band AP that works at 2.4 GHz frequency band, AP2 and AP3 are all dual-band APs. AP1 and AP2 use 2.4 GHz radio to set up wireless virtual links (WVLs), while AP2 and AP3 use 5 GHz radio to set up WVLs. AP3 connects STAs to the WLAN through the 2.4 GHz radio. On a hand-in-hand WDS network, AP1, AP2, and AP3 use different radios to set up WVLs.
Figure 8-5  Hand-in-hand WDS networking applications

NOTE:

In the figure, AP2 on 2.4 GHz radio functions as a leaf node for AP1 and AP2 on 5 GHz radio functions as a root node for AP3.

If the APs supporting dual 5G radios, such as the AP8130DN are used as AP1 and AP2, you can set radio 0 of the two APs to the 5G radio.

Back-to-Back WDS Networking

In outdoor scenarios, such as school campus, plantations, and mountain areas, wired networks are difficult to deploy. When networks to be connected are far from each other or blocked by obstacles, APs can be cascaded as trunk bridges in back-to-back mode. This networking ensures sufficient bandwidth on wireless links for long distance data transmission. Figure 8-6 shows the back-to-back WDS networking.
Figure 8-6  Back-to-back WDS networking

Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100033726

Views: 36400

Downloads: 220

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next