No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Interoperation Configuration Guide

AR Router

This document provides cases for connecting AR enterprise routers to devices of other vendors.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RouterB

Configuring RouterB

Configuration Roadmap

The configuration roadmap is as follows:
  1. Set the type of the ISDN PRI interface to primary-net5.
  2. Add an E1 card and configure an E1 interface.
  3. Configure a signaling interface.
  4. Configure a dialup peer.

Procedure

  1. Set the type of the ISDN PRI interface to primary-net5.

    Router> enable
    Router# configure terminal
    RouterB(config)# hostname RouterB
    RouterB(config)# isdn switch-type primary-net5
    

  2. Add an E1 card and configure an E1 interface.

    RouterB(config)# card type e1 0 0
    RouterB(config)# controller E1 0/0/0
    RouterB(config-controller)# framing NO-CRC4
    RouterB(config-controller)# pri-group timeslots 1-5,16
    RouterB(config-controller)# exit
    

  3. Configure a signaling interface.

    RouterB(config)# interface Serial0/0/0:15
    RouterB(config-if)# no ip address
    RouterB(config-if)# encapsulation hdlc
    RouterB(config-if)# isdn switch-type primary-net5
    RouterB(config-if)# isdn overlap-receiving
    RouterB(config-if)# isdn incoming-voice voice
    RouterB(config-if)# no cdp enable
    RouterB(config-if)# exit
    

  4. Configure a dialup peer.

    RouterB(config)# dial-peer voice 6101 pots
    RouterB(config-dial-peer)# destination-pattern 6101
    RouterB(config-dial-peer)# port 0/1/0
    RouterB(config-dial-peer)# exit
    RouterB(config)# dial-peer voice 86 pots
    RouterB(config-dial-peer)# destination-pattern 86T
    RouterB(config-dial-peer)# port 0/0/0:15
    RouterB(config-dial-peer)# exit
    RouterB(config)# exit
    

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1100034005

Views: 21133

Downloads: 447

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next