No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Interoperation Configuration Guide

AR Router

This document provides cases for connecting AR enterprise routers to devices of other vendors.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Cisco CUCM

Configuring the Cisco CUCM

Configuration Roadmap

The configuration roadmap is as follows:

  1. Configure a SIP trunk.

  2. Configure parameters of the remote device, such as the IP address and port number.

  3. Configure a routing rule.

Procedure

  1. Access the CUCM main menu and choose Device > Trunk to access the Trunk Configuration page, as shown in Figure 14-3. Set Trunk Type to SIP Trunk, specify SIP, and click Next.

    Figure 14-3  Trunk configuration

  2. In Device Information, enter parameters of the remote device, such as the name of the remote device, as shown in Figure 14-4.

    Figure 14-4  Device information

  3. In SIP Information, enter the IP address and port number of the remote device, as shown in Figure 14-5.

    Figure 14-5  SIP information

  4. Click Save to save configured parameters. Click Reset to make the configuration take effect.
  5. Choose Call Routing > Route/Hunt > Route Pattern to configure a routing rule. The routing rule is triggered when the Cisco CUCM receives a called number that starts with 82 and has three characters following 82. Select the IP address of the CUCM from the Gateway/Router List drop-down list box. Click Save to save the configuration, as shown in Figure 14-6.

    Figure 14-6  Configuring a routing rule

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1100034005

Views: 20362

Downloads: 436

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next