No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Interoperation Configuration Guide

AR Router

This document provides cases for connecting AR enterprise routers to devices of other vendors.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RouterB

Configuring RouterB

Configuration Roadmap

  1. Set the ISDN switching type to basic-net3.
  2. Configure the BRI interface to send SETUP messages and process voice packets.
  3. Configure the dialup peer, specify allowed number 9001, and configure narrowband trunk parameters.

Procedure

  1. Configure the switching type of the BRI interface and configure the BRI interface to send SETUP messages.

    Router> enable
    Router# configure terminal
    Router(config)# hostname RouterB       
    RouterB(config)# isdn switch-type basic-net3
    RouterB(config)# interface BRI0/0/1
    RouterB(config-if)# shutdown
    RouterB(config-if)# isdn switch-type basic-net3 
    RouterB(config-if)# isdn incoming-voice voice
    RouterB(config-if)# no shutdown
    RouterB(config-if)# exit

  2. Step 2 Configure the dialup peer and save the configuration.

    RouterB(config)# dial-peer voice 9001 pots
    RouterB(config-dial-peer)# destination-pattern 9001 
    RouterB(config-dial-peer)# port 0/1/0
    RouterB(config-dial-peer)# exit
    RouterB(config)# dial-peer voice 62 pots
    RouterB(config-dial-peer)# destination-pattern .T
    RouterB(config-dial-peer)# port 0/0/1
    RouterB(config-dial-peer)# exit
    RouterB(config)# exit
    RouterB# write

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1100034005

Views: 20297

Downloads: 434

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next