No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Interoperation Configuration Guide

AR Router

This document provides cases for connecting AR enterprise routers to devices of other vendors.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Cisco Router

Configuring the Cisco Router

Configuration Roadmap

  1. Configure IP addresses for interfaces of the Cisco router.
  2. Configure OSPF routes.


  1. Configure an IP address for GE0/1 of the Cisco router. By default, the network type of Ethernet interfaces is broadcast. Therefore, the OSPF network type does not need to be configured here.

    Configuring from terminal, memory, or network [terminal]?
    Enter configuration commands, one per line.End with CNTL/Z.
    server(config)#interface gigabitEthernet 0/1
    server(config-if)#ip address

  2. Configure an OSPF route.

    server(config)#router ospf 1
    server(config-router)#network area 0
    % OSPF: Reload or use "clear ip ospf process" command, for this to take effect

Updated: 2019-05-17

Document ID: EDOC1100034005

Views: 27553

Downloads: 501

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next