No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
POE_1.3.6.1.4.1.2011.5.25.195.40.4 hwPoeSlotPowerOverload

POE_1.3.6.1.4.1.2011.5.25.195.40.4 hwPoeSlotPowerOverload

Description

POE/4/UNITPOWEROVERTHRESHOLD: OID [oid] Slot [ULONG1] is overdrawing power. It is consuming [ULONG2] milliwatts while maximum configured power is [ULONG3] milliwatts.

The power required by a PD on a specified slot increases; therefore, the slot power supply is insufficient.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.195.40.4 Warning equipmentAlarm(5)

Parameters

Name Meaning
OID

Indicates the MIB object ID of the alarm.

[ULONG1] Indicates the slot ID of a PoE-capable card.
[ULONG2] Indicates the current power of the PD.
[ULONG3] Indicates the maximum power configured.

Impact on the System

The PD with a lower priority will be powered off if the slot power supply is insufficient.

Possible Causes

Cause 1:

The power required by the PD in a specified slot increases.

Cause 2:

The maximum power of the PoE-capable card in the slot is adjusted to a smaller value.

Procedure

  1. Run the display poe information slot slot-id command to check the maximum power configured for the specified slot.
  2. Run the display poe power slot slot-id command to check the current power required by the PD connected to each interface on the specified slot.
  3. Perform the following steps as required:

    • If the maximum PoE power configured for the specified slot is smaller than the total power required by the PDs, run the poe slot slot-id max-power max-power command to increase the PoE power. Ensure that the PoE power is sufficient for all the PDs connected to the PoE-capable card.

    • If the maximum PoE power is smaller than the total power required by the PDs but cannot be increased, run the poe priority { critical | high | low } command to set power supply priorities for PDs. Then low-priority PDs are powered off and power supply of high-priority PDs is ensured.

Translation
Download
Updated: 2019-05-07

Document ID: EDOC1100034065

Views: 131758

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next