No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
DSVPN_1.3.6.1.4.1.2011.6.122.73.0.2.4 hwNHRPHubDOWN

DSVPN_1.3.6.1.4.1.2011.6.122.73.0.2.4 hwNHRPHubDOWN

Description

NHRP/4/NHRPHUBDOWN: OID [oid] NHRP hub is down. (Interface=[interface-name], protocol-address=[protocol-address], mask=[mask], next-hop=[next-hop-address], nbma-address=[nbma-address])

The status of the Hub's NHRP mapping entry is Down.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.6.122.73.0.2.4 Warning Communications alarm

Parameters

Name Meaning
OID

Indicates the MIB object ID of the alarm.

Interface

Indicates the tunnel interface name specified in the NHRP mapping entry.

protocol-address

Indicates the protocol address in the NHRP mapping entry.

mask

Indicates the mask of the protocol address.

next-hop

Indicates the next-hop IP address to the protocol address.

nbma-address

Indicates the public network address in the NHRP mapping entry.

Impact on the System

Services are not affected.

Possible Causes

  • The tunnel interface is Down.

  • The IPSec tunnel status changes.

  • The APN status is Down.

Procedure

  1. Check whether the configuration is correct.
  2. Check whether the status down of the Hub's NHRP mapping entry is caused by a normal operation.
  3. If a misoperation is performed, contact technical support personnel.
Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100034065

Views: 150074

Downloads: 42

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next