No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ISIS_1.3.6.1.4.1.2011.5.25.24.2.4.12 hwIsisSystemIdAutoRecover

ISIS_1.3.6.1.4.1.2011.5.25.24.2.4.12 hwIsisSystemIdAutoRecover

Description

ISIS/2/SYSTEM_ID_AUTO_RECOVER:OID [oid] After a system ID conflict was detected within an IS-IS area, IS-IS changed the system ID automatically. (hwisisSysInstance=[integer], hwISISConflictSystemID=[opaque], hwISISAutoSysId=[opaque], hwISISLocalIP=[ipaddr], hwISISRemoteIP=[ipaddr])

After a system ID conflict was detected, IS-IS changed the conflicting system ID automatically.

Attribute

Alarm ID Alarm Severity Alarm Type

1.3.6.1.4.1.2011.5.25.24.2.4.12

Major

communicationsAlarm(2)

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

hwisisSysInstance

ID of an IS-IS process

hwISISConflictSystemID

Conflicting system ID

hwISISAutoSysId

New system ID generated

hwISISLocalIP

Local IP address

hwISISRemoteIP

Peer IP address

Impact on the System

v

Possible Causes

If devices on the network use the same system ID, Link state protocol data units (LSPs) are frequently updated, and route flapping occurs.

Procedure

  1. This log is informational only, and no action is required.

Related Information

None

Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100034065

Views: 144604

Downloads: 42

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next