No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Alarm Handling

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
LSPM_1. hwMplsTunnelHSBResume

LSPM_1. hwMplsTunnelHSBResume


LSPM/3/MPLSTUNNELHSBRESUME:OID [oid] Main LSP of Tunnel resumes from backup LSP in HSB.(SessionTunnelId=[integer], LocalLspId=[integer], IngressLsrId=[integer], EgressLsrId=[integer], MplsTunnelAdminStatus=[integer], MplsTunnelOperStatus=[integer])

The trap message was output when the primary CR-LSP went Up and traffic was switched back from the hot-standby CR-LSP to the primary CR-LSP.


Alarm ID Alarm Severity Alarm Type




Name Meaning


Indicates the MIB object ID of the alarm.


Indicates the ID of the tunnel.


Indicates the local LSP ID of a tunnel.


Indicates the LSR ID of the ingress on the tunnel.


Indicates the LSR ID of the egress on the tunnel.


Indicates the management status of the tunnel.
  • 1: Up
  • 2: Down


Indicates the operating status of the tunnel:
  • 1: Up
  • 2: Down

Impact on the System

Services will not be affected.

Possible Causes

When the tunnel was in the HSB inuse state, the status of the primary LSP changed from Down to Up.


  • This trap message is informational only, and no action is required.
Updated: 2019-08-12

Document ID: EDOC1100034065

Views: 151314

Downloads: 42

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next