No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VFSTRAP_1.3.6.1.4.1.2011.6.9.1.3.3 hwFlhSyncFailNotification

VFSTRAP_1.3.6.1.4.1.2011.6.9.1.3.3 hwFlhSyncFailNotification

Description

VFSTRAP/4/STORAGE_DEVICE_FAIL :OID [OID] Copy Failed.(Serial number=[INTEGER], Source file = [STRING1], Destination file = [STRING2])

A synchronization instance created by hwFlhSyncTable failed.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.6.9.1.3.3 Warning equipmentAlarm

Parameters

Name Meaning
OID

Indicates the MIB object ID of the alarm.

Serial number Indicates the operation serial number.
Source file Indicates the source file in the synchronization operation.
Destination file Indicates the destination file in the synchronization operation.

Impact on the System

None.

Possible Causes

1:

The source file does not exist.

2:

The storage space is insufficient.

Procedure

  1. Run the dir command to check whether the source file exists.

    • If so, go to step 3.
    • If not, go to step 2.

  2. Place the source file and copy the file again. Check whether the file is copied successfully.

    • If so, the procedure ends.
    • If not, go to step 3.

  3. Run the dir command to check whether the storage space is sufficient.

    • If so, go to step 5.
    • If not, go to step 4.

  4. Delete unneeded files to release space. Check whether the file can be copied successfully.

    • If so, the procedure ends.
    • If not, go to step 5.

  5. Collect alarm information and configuration information, and then contact technical support personnel..
Translation
Download
Updated: 2019-05-07

Document ID: EDOC1100034065

Views: 131430

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next