No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
PIM_1.3.6.1.4.1.2011.5.25.149.4.0.9 hwPimMrtLimit

PIM_1.3.6.1.4.1.2011.5.25.149.4.0.9 hwPimMrtLimit

Description

PIM/1/MRTLIMIT:OID [oid] PIM entries cannot be created because the upper limit is crossed. (GrpAddrType=[integer], SrcAddr=[binary], GrpAddr=[binary], InstanceID=[integer], InstanceName=[string])

The number of PIM entries exceeds the upper limit defined in the License file. (To check the upper limit defined in the License file, run the display multicast paf-license command. The paf value in PAF_LCS_ROUT_MCAST_PIM_MAX_WC_ENTRY_NUM and PAF_LCS_ROUT_MCAST_PIM_MAX_SG_ENTRY_NUM in the command output indicates the upper limit defined in the License file.)

Attribute

Alarm ID Alarm Severity Alarm Type

1.3.6.1.4.1.2011.5.25.149.4.0.9

Critical

processingErrorAlarm(4)

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

GrpAddrType

Indicates the inetAddressType of the multicast group address. The value can be:
  • 1: IPv4 address

  • 2: IPv6 address

SrcAddr

Indicates the source address of the entry.

GrpAddr

Indicates the group address of the entry.

InstanceID

Indicates the ID of the instance to which the entry belongs.

InstanceName

Indicates the name of the instance to which the entry belongs.

Impact on the System

After the number of PIM entries reaches the upper limit defined in the License file, no more PIM entries can be added.

Possible Causes

Adding PIM entries fails because the number of PIM entries reaches the upper limit defined in the License file.

Procedure

  1. Run the display pim routing-table command to check whether the number of existent PIM entries reaches the upper limit defined in the License file.

    • If so, go to Step 2.

    • If not, go to Step 3.

  2. The number of multicast entries reaches the upper limit and no more entries can be added. Then, you are recommended to reduce the deployed multicast services or replace the device with a higher-performance device to solve the problem, go to Step 4.
  3. Collect alarm information and configuration information, and then contact technical support personnel.
  4. End.

Related Information

None

Translation
Download
Updated: 2019-05-07

Document ID: EDOC1100034065

Views: 132623

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next