No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
WLAN_1.3.6.1.4.1.2011.6.139.13.1.1.29 hwApNotSupportCountryCodeTrap

WLAN_1.3.6.1.4.1.2011.6.139.13.1.1.29 hwApNotSupportCountryCodeTrap

Description

WLAN/4/AP_NOT_SUPPORT_CONFIGURED_COUNTRY_CODE:OID [oid] AP not support configured country code notify.(APMAC=[MacAddress], APName=[STRING], COUNTRY CODE=[OCTET], APID=[INTEGER])

The AP does not support the country code configured on the AC.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.6.139.13.1.1.29 Warning equipmentAlarm(5)

Parameters

Name Meaning
OID Indicates the ID of the MIB object.
APMAC Indicates the MAC address of an AP.
APName Indicates the AP name.
COUNTRY CODE Indicates the country code configured on the AP.
APID Indicates the AP ID.

Impact on the System

The AP cannot get online.

Possible Causes

A country code not supported by the AP is configured on the AC.

Procedure

  1. Run the display regulatory-domain-profile { all | name profile-name } command to check whether the country code configured on the AC is the same as that supported by the AP.

    • If the country codes are the same, go to Step 3.
    • If the country codes are different, go to Step 2.

  2. Run the country-code country-code command to set the country code of the AC to the one supported by the AP.

    • If the alarm persists, go to Step 4.
    • If the alarm is cleared, go to Step 5.

  3. Collect alarm messages, log messages, and configurations, and then contact the technical support personnel.
  4. End.

Related Information

None.

Translation
Download
Updated: 2019-05-07

Document ID: EDOC1100034065

Views: 130755

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next