No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
WLAN_1.3.6.1.4.1.2011.6.139.16.1.1.1.11 hwOtherDeviceInterfDetectedTrap

WLAN_1.3.6.1.4.1.2011.6.139.16.1.1.1.11 hwOtherDeviceInterfDetectedTrap

Description

WLAN/4/UNKNOW_DEVICE_DISTURB: OID [oid] Jam of Other devices is detected.(APMAC=[OPAQUE], RadioID=[INTEGER],ApName=[OCTET], APID=[INTEGER])

Interference from other devices is detected.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.6.139.16.1.1.1.11 Warning equipmentAlarm(5)

Parameters

Name Meaning
OID Indicates the ID of the MIB object.
APMAC Indicates the MAC address of an AP.
RadioID Indicates the radio ID.
ApName Indicates the AP name.
APID Indicates the AP ID.

Impact on the System

The packet loss rate increases, the data rate decreases, and even the services may be interrupted.

Possible Causes

Devices, except for the co-channel APs, adjacent-channel APs, and STAs, worked on the AP channel and interfered with the AP.

Procedure

  1. No action is required.

    If severe interference deteriorates the environment, it will trigger local radio calibration, and the APs will automatically adjust the channel and power. Then, check whether the alarm persists.

    • If so, go to Step 2.
    • If not, go to Step 3.

  2. Collect alarm messages, log messages, and configurations, and then contact the technical support personnel.
  3. End.

Related Information

None.

Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100034065

Views: 144162

Downloads: 42

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next