No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
GTL_1.3.6.1.4.1.2011.5.25.142.2.2 hwGtlResourceUsedUp

GTL_1.3.6.1.4.1.2011.5.25.142.2.2 hwGtlResourceUsedUp

Description

GTL/4/RESOURCE_USEDUP:OID [OID] Resource item [hwGtlResourceItem] is nearly used up.

The trap was generated when the percentage of the resources used by the service module was not less than the 90% which is defined by the license.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.142.2.2 Warning equipmentAlarm(5)

Parameters

Name Meaning
OID

Indicates the MIB object ID of the alarm.

hwGtlResourceItem indicates the name of the resource item.

Impact on the System

Under the control of the license, the usage percentage of service resources cannot exceed the threshold defined by the license. Therefore, if a larger license file cannot be applied for or activated, traffic loads may not cater for the demand of the current operation scenario.

Possible Causes

The usage percentage of service resources reached or exceeded 90% of the threshold defined by the license.

Procedure

  1. Confirm whether the current license file is large enough. If not, apply for a larger license file.
  2. Use the new license file and run the license active license-name command to activate it.
  3. For other causes, contact technical support personnel.

Related Information

None

Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100034065

Views: 152563

Downloads: 42

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next