No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
DSVPN_1.3.6.1.4.1.2011.6.122.73.0.2.1 hwNHRPPeerADD

DSVPN_1.3.6.1.4.1.2011.6.122.73.0.2.1 hwNHRPPeerADD

Description

NHRP/4/NHRPPEERADD: OID [oid] NHRP peer is added. (Interface=[interface-name], protocol-address=[protocol-address], mask=[mask], next-hop=[next-hop-address], nbma-address=[nbma-address], type=[peer-type])

An NHRP mapping entry is added.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.6.122.73.0.2.1 Warning Communications alarm

Parameters

Name Meaning
oid

Indicates the MIB object ID of the alarm.

interface-name

Indicates the tunnel interface name specified in the NHRP mapping entry.

protocol-address

Indicates the protocol address in the NHRP mapping entry.

mask

Indicates the mask of the protocol address.

next-hop-address

Indicates the next-hop IP address to the protocol address.

nbma-address

Indicates the public network address in the NHRP mapping entry.

peer-type
Indicates the type of the NHRP mapping entry. The value can be:
  • hub: The NHRP mapping entry is generated during NHRP registration.
  • static: The NHRP mapping entry is configured by the administrator.
  • dynamic: The NHRP mapping entry is dynamically generated by the device.

Impact on the System

Services are not affected.

Possible Causes

Cause 1:

A user runs the nhrp entry command to add an NHRP mapping entry.

Cause 2:

The NHRP mapping entry is generated dynamically.

Procedure

  • This log message is informational only, and no action is required.
Translation
Download
Updated: 2019-05-07

Document ID: EDOC1100034065

Views: 132151

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next