No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Basic Configuration

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the Basic configuration supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for Auto-Start

Licensing Requirements and Limitations for Auto-Start

This section provides licensing requirements and limitations for Auto-Start.

Involved Network Elements

None

Licensing Requirements

Auto-Start is a basic feature of a router and is not under license control.

Feature Limitations

  • The device can be deployed using a USB flash drive, Auto-Config, or Auto-Start. The three deployment modes are mutually exclusive and only one of them can be used at a time.
  • The intermediate file contains the mapping between the device's MAC address + ESN and the system software, version, patch file, and configuration file. After connecting to the file server, the device downloads and parses the intermediate file, and downloads corresponding version files from the file server based on the parsing result. Before using Auto-Start, obtain the device's system MAC address and ESN using the following methods:
    • View the barcode label attached to the surface of the device.
    • Log in to the device and run the display system-mac (diagnostic view) and display esn (All views) commands to view the MAC address and ESN, respectively.
Translation
Download
Updated: 2019-08-08

Document ID: EDOC1100034066

Views: 83460

Downloads: 466

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next