No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Basic Configuration

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the Basic configuration supported by the device.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Backing Up the Configuration File

Example for Backing Up the Configuration File

Networking Requirements

As shown in Figure 12-2, a user logs in to the device and backs up the configuration file to the TFTP server. So the configuration file can be recovered in case that the device is damaged.

Figure 12-2  Networking diagram of backing up the configuration file

Configuration Roadmap

The configuration roadmap is as follows:

  1. Save the configuration file.

  2. Back up the configuration file through TFTP.

    Configuration file backup through TFTP is simple, but there are security risks. In scenarios with high security requirements, configuration file backup through SFTP is recommended. The following describes the configuration file backup process using TFTP as an example.


  1. Save configurations to the config.cfg file.

    <Huawei> save config.cfg

  2. Back up the configuration file through TFTP.
    1. Start the TFTP server program.

      Start the TFTP server program on the PC. Set the path for transmitting the configuration file, and the IP address and port number of the TFTP server.

    2. Transfer the configuration file.

      # Run the tftp command in the user view to back up the specified configuration file.

      <Huawei> tftp put sd1:/config.cfg backup.cfg

Updated: 2019-11-21

Document ID: EDOC1100034066

Views: 99214

Downloads: 519

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next