No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Basic Configuration

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the Basic configuration supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining Auto-Start

Maintaining Auto-Start

You can monitor the running status of Auto-Start in each phase to ensure that Auto-Start runs normally.

  • Run the display autostart status command to display the running status of Auto-Start.
  • Run the display startup command to display the system software and configuration files for the current and next startup.
NOTE:
  • If the device is connected to the network, you can log in to the device using Telnet or other modes to view the Auto-Start running status, but do not configure the device.
  • After downloading a file, do not save the configuration on the device because the configuration has not taken effect. If you save the configuration, the configuration will not take effect after the site deployment process ends.
  • You can view the file transfer log on the file server to check whether the device has successfully downloaded the correct system software, patch file, and configuration file.
  • If the Auto-Start process is suspended, you can reconfigure file server parameters or the intermediate file and file server, enter the autostart view, and run the autostart run command to manually restart the Auto-Start process.
Translation
Download
Updated: 2019-08-08

Document ID: EDOC1100034066

Views: 83912

Downloads: 472

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next