No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Basic Configuration

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the Basic configuration supported by the device.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Auto-Start On a Device

Configuring Auto-Start On a Device

This section describes how to configure Auto-Start on a device.

Pre-configuration Tasks

Power on the device and ensure that it completes self-check successfully.


  1. Configure a management IP address for the device.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. Run ip address ip-address { mask | mask-length }

      A management IP address is configured.

      The management IP address is used for device management and maintenance. Configure IP addresses and deploy routes based on network planning to ensure that routes between terminals and devices are reachable.

    4. Run quit

      Exit from the interface view.

  2. Configure file server parameters.
    1. Run autostart

      The autostart view is displayed.

    2. Run servertype { ftp | sftp }

      The type of the file server is configured.

      By default, the file server is an FTP server.

    3. Run ipaddress ip

      The IP address of the file server is configured.

    4. Run username username password password

      The user name and password for accessing the file server are configured.

      By default, no user is configured for accessing the file server.

    5. Run quit

      Return to the system view.

    6. Run autostart enable

      Auto-Start is enabled.

      By default, Auto-Start is disabled on a device.

    7. Run quit

      Return to the user view.

  3. Run save

    The configuration is saved.

Verifying the Configuration

Run the display autostart config command to view configured file server parameters, including the type and IP address of the file server, and the user name and password for accessing the file server.

Follow-up Procedure

After being installed and powered on, the device starts the Auto-Start process.

After the Auto-Start process successfully ends, you are advised to run the undo autostart enable command to disable Auto-Start and run the save command to save the configuration, preventing the device from starting the Auto-Start process again after it restarts the next time.

Updated: 2019-11-21

Document ID: EDOC1100034066

Views: 97979

Downloads: 512

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next