No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Basic Configuration

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the Basic configuration supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling Auto-Config

Enabling Auto-Config

Context

Auto-Config needs to be enabled when:

  • Auto-Config is disabled on the current device. In this case, you can run the display autoconfig enable command to check whether Auto-Config is enabled. Auto-Config must be enabled before it runs.

  • If the Auto-Config function cannot be automatically recovered after an error occurs in the Auto-Config process, run the undo autoconfig enable command to disable the Auto-Config function. You can use the display autoconfig-status command to check whether Auto-Config is enabled. When Auto-Config is in stop state (you can run the display autoconfig-status command to check the Auto-Config status), enable Auto-Config again.

    • This task is performed on the device with no startup configuration file.

    • By default, Auto-Config is enabled. Therefore, Auto-Config does not need to be performed on the new device.

Auto-Config can be disabled in the following way:
  • Run the undo autoconfig enable command in the system view to disable Auto-Config. When Auto-Config is in stop state (you can run the display autoconfig-status command to check the Auto-Config status), enable Auto-Config again.
  • Log in to the device through the console interface. If the following information "Auto-Config is working. Before configuring the device, stop Auto-Config. If you perform configurations when Auto-Config is running, the DHCP, routing, DNS, and VTY configurations will be lost. Do you want to stop Auto-Config? [y/n]:" is displayed, enter y to stop the Auto-Config process.

Procedure

  1. (Optional) Run display autoconfig enable

    Check whether Auto-Config is enabled.

  2. Run system-view

    The system view is displayed.

  3. Run autoconfig enable

    Auto-Config is enabled.

Translation
Download
Updated: 2019-11-21

Document ID: EDOC1100034066

Views: 89053

Downloads: 486

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next