No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Network Management Function for RIP

Configuring the Network Management Function for RIP

By binding RIP to the MIB, you can view RIP information and configure RIP through the NMS.

Pre-configuration Tasks

Before configuring the network management function for RIP, complete the following task:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run rip mib-binding process-id

    RIP is bound to the MIB.

    This command is used to bind a RIP process ID to MIBs and specify the ID of the RIP process that accepts Simple Network Management Protocol (SNMP) requests.

Verifying the Configuration

  • Run the display current-configuration command to view the binding relationships of RIP.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 111073

Downloads: 163

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next