No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Advertising a Default Route

Advertising a Default Route

Context

In an IPv6 routing table, a default route is a route to network ::/0. If the destination address of a packet does not match any entry in the routing table, the packet is sent through a default route.

There are two methods to advertise RIPng default routes. You can configure a device to advertise RIPng default routes according to networking requirements.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ripng default-route { only | originate } [ cost cost ]

    The device is configured to advertise RIPng default routes.

    By default, there is no default route in the RIPng routing domain.

    Configure the device to advertise default routes according to networking requirements:

    • only: configures the device to advertise only IPv6 default routes (::/0), suppressing the advertisement of other routes. If the local device is located on the network edge and the details of the local network need to be hidden, you can set this parameter to enable the devices on other networks to access the local network only through the local device.

    • originate: configures the device to advertise IPv6 default routes (::/0) without affecting the advertisement of other routes. If the local device is located on the network edge and some details of the local network need to be hidden, you can set this parameter to enable the devices on other networks to use the default route when connecting to certain devices on the local network.

    The device advertises generated RIPng default routes using Update packets through a specified interface regardless of whether these routes exist in the local IPv6 routing table.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 110357

Downloads: 160

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next