No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling BFD for OSPFv3

Enabling BFD for OSPFv3

On the two routers that need to establish a BFD session, you can configure BFD for all the interfaces in a certain OSPFv3 process.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bfd

    BFD is globally configured.

  3. Run quit

    Return to the system view.

  4. Run ospfv3 process-id

    The OSPFv3 view is displayed.

  5. Run bfd all-interfaces enable

    BFD for OSPFv3 is enabled to establish a BFD session.

    By default, BFD is disabled at OSPFv3 process level.

Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100034072

Views: 121791

Downloads: 180

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next