No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
IS-IS NSR

IS-IS NSR

As networks develop, the demand for data, audio, and video services is growing, which imposes increasing requirements on IP network reliability. If an AMB/SMB switchover is performed on a device due to a maintenance operation or a single point of failure, routes may fail to converge, which may result in traffic loss or even a network breakdown. Non-stop routing (NSR) can address this problem and ensure uninterrupted forwarding of key services.

With Routing Information Protocol next generation (IS-IS) NSR, IS-IS real-time data is synchronized between the AMB and SMB. After an AMB/SMB switchover is performed on a device, the SMB takes over services from the AMB, and neighbors are unaware of the local fault. After the switchover, the new AMB recovers IS-IS immediately based on the synchronized IS-IS real-time data. Therefore, neighbors are unaware of the switchover as well. IS-IS NSR requires synchronization of the following data:

  • All configuration data, such as information about neighbors, timer parameters, and process configurations.

  • Dynamic data, such as the interface parameters and state, and information about neighbors and the link state database (LSDB).

NOTE:

Only the AR3200 series support NSR.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 111290

Downloads: 163

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next