No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Creating OSPF Virtual Links

(Optional) Creating OSPF Virtual Links

Context

After OSPF areas are defined, OSPF route updates between non-backbone areas are transmitted through a backbone area. Therefore, OSPF requires that all non-backbone areas maintain connectivity with the backbone area and that the backbone areas in different OSPF areas maintain connectivity with each other. In real world situations, this requirement may not be met because of certain restrictions. To resolve this problem, you can configure OSPF virtual links.

Perform the following steps on the router running OSPF.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run area area-id

    The OSPF area view is displayed.

  4. Run vlink-peer router-id [ smart-discover | hello hello-interval | retransmit retransmit-interval | trans-delay trans-delay-interval | dead dead-interval | [ simple [ plain plain-text | [ cipher ] cipher-text ] | { md5 | hmac-md5 | hmac-sha256 } [ key-id { plain plain-text | [ cipher ] cipher-text } ] | authentication-null | keychain keychain-name ] ] *

    A virtual link is created.

    This command must also be configured on the neighboring router.

    If plain is selected, the password is saved in the configuration file in plain text. This brings security risks. It is recommended that you select cipher to save the password in cipher text.

    MD5 authentication and HMAC-MD5 authentication have potential security risks. HMAC-SHA256 authentication mode is recommended.

Follow-up Procedure

After virtual links are created, different default MTUs may be used on devices provided by different vendors. To ensure consistency, the MTU is set to 0 by default when the interface sends DD packets. For details, see Configuring an Interface to Fill in the DD Packet with the Actual MTU.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 111206

Downloads: 163

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next