No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Stub Routers

Configuring Stub Routers

Context

A stub router is used to control traffic. It notifies OSPFv3 routers not to forward data by the stub router, but they can have a route to the stub router.

Do as follows on the router that runs OSPFv3:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 [ process-id ]

    The OSPFv3 process view is displayed.

  3. Run stub-router [ on-startup [ interval ] ]

    The stub router is configured.

    NOTE:

    There is no correlation between the stub router configured through this command and the router in the stub area.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 110098

Downloads: 160

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next