No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RIPng Route Summarization

Configuring RIPng Route Summarization

Context

Route summarization can reduce the routing table size and minimize impact of route flapping on the network.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ripng summary-address ipv6-address prefix-length [ avoid-feedback ]

    RIPng route summarization is configured.

    By default, a RIPng router does not advertise summarized IPv6 addresses.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 110785

Downloads: 163

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next