No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Entering the OSPFv3 Area View

Entering the OSPFv3 Area View

Context

You must configure the routers in the same area based on the area. Otherwise, the neighbor routers cannot exchange information with each other. The congestion of routing information or routing loop is thus caused.

Do as follows on the router that runs OSPFv3.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 [ process-id ]

    The OSPFv3 view is displayed.

  3. Run area area-id

    The OSPFv3 area view is displayed.

    The area ID can be a decimal integer or in the IPv4 address format, but it is displayed in the IPv4 address format.

    An OSPFv3 area cannot be deleted directly. Only after all the configurations in the area view are removed, this area is automatically removed.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 111184

Downloads: 163

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next