No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Specifying the RIP Version

(Optional) Specifying the RIP Version

Context

RIP versions include RIP-1 and RIP-2. The two versions have different functions. The RIP version must be set on the device running RIP. You only need to set the global RIP version unless you want to specify a different RIP version on an interface.

Procedure

  • Configure the global RIP version.
    1. Run the system-view command to enter the system view.
    2. Run the rip [ process-id ] command to enter the RIP view.
    3. Run the version { 1 | 2 } command to set the global RIP version.

      NOTE:

      By default, an interface sends only RIP-1 packets and receives both RIP-1 and RIP-2 packets.

  • Configure the RIP version for an interface.
    1. Run the system-view command to enter the system view.
    2. Run the interface interface-type interface-number command to enter the interface view.
    3. Run the rip version { 1 | 2 [ broadcast | multicast ] } command specify the RIP version on the specified interface.

      NOTE:
      • By default, an interface sends only RIP-1 packets and receives both RIP-1 and RIP-2 packets.
      • If no RIP version number is configured in the interface view, the global RIP version is used. The RIP version set on an interface takes precedence over the global RIP version.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 111068

Downloads: 163

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next