No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Failed to Send RIP Update Packets to Neighbors

Failed to Send RIP Update Packets to Neighbors

Fault Description

A device cannot send RIP Update packets to neighbors when the link runs properly.

Procedure

  1. Run the display current-configuration configuration rip command to check RIP configurations.

    • Check whether RIP has been enabled on the interface. Only the RIP-enabled interface can send RIP packets.
    • Check whether the silent-interface command has been executed on the interface. If the command has been executed, the interface does not send RIP packets.

  2. Run the display current-configuration interface interface-type interface-number command to view the interface configuration.

    • Check whether the undo rip output command has been executed on the interface. If the command has been executed, the interface does not send RIP packets.
    • Check whether the authentication modes on the two ends of the link are the same. If the authentication modes are different, the interface cannot send RIP packets to the peer.
    • Check whether split horizon has been enabled on the interface. If split horizon has been enabled, the interface cannot send the route learned by itself to neighbors.
      NOTE:

      Split horizon is enabled on all interfaces by default, but the display current-configuration command output does not show the split horizon option. If the command output for an interface connected to an NBMA network does not contain the split horizon option, split horizon is disabled on the interface.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 109561

Downloads: 155

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next