No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPv6 Static Routes

Configuring IPv6 Static Routes

On a network, you can accurately control route selection by configuring IPv6 static routes.

Pre-configuration Tasks

Before configuring IPv6 static routes, complete the following task:

  • Configuring link layer parameters and IPv6 addresses for interfaces to ensure network-layer communication between neighbor nodes

Configuration Procedure

You can perform the following configuration tasks (excluding the task of Verifying the IPv6 Static Route Configuration) in any sequence as required.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 109804

Downloads: 157

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next