No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Optimizing an OSPFv3 Network

Optimizing an OSPFv3 Network

Applicable Environment

By adjusting the OSPFv3 timer, you can change the convergence speed of an OSPFv3 network and the network overload caused by protocol packets. On low-speed links, you need to consider the delay in transmitting LSAs on the interface. By adjusting the SPF calculation interval, you can mitigate resource consumption due to frequent network changes.

You can specify the DR priority of an interface to affect the DR/BDR election in a broadcast network.

Pre-configuration Tasks

Before optimizing an OSPFv3 network, complete the configuration tasks:

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 109917

Downloads: 158

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next