No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Disabling Master/Slave Board Switching Triggered by Abnormal OSPF LSA Aging

Disabling Master/Slave Board Switching Triggered by Abnormal OSPF LSA Aging

By default, master/slave board switching triggered by abnormal OSPF LSA aging is enabled. To disable this function, perform this task.

Context

If the local device clock is faster than usual and the aging timer expires abnormally, the local device incorrectly clears all Router LSAs from the peer device, which causes route flapping and service interruptions. To resolve this issue, master/slave board switching triggered by abnormal OSPF LSA aging is automatically enabled. Master/slave board switching is triggered to restore network connections and service traffic when the following condition is met:

(Number of incorrectly cleared Router LSAs/Total number of Router LSAs) x 100% ≥ 80% (Router LSAs are those sent by the peer device to the local device)

To disable master/slave board switching triggered by abnormal OSPF LSA aging, run the ospf maxage-lsa auto-protect disable command.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf maxage-lsa auto-protect disable

    The master/slave board switching triggered by abnormal OSPF LSA aging is disabled.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 109340

Downloads: 155

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next