No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
RIP-2 Enhanced Features

RIP-2 Enhanced Features

Two versions are available for RIP: RIP-1 and RIP-2. RIP-2 is an extension to RIP-1.

Comparison Between RIP-1 and RIP-2

RIP version 1 (RIP-1) is a classful (as opposed to classless) routing protocol. It supports the advertisement of protocol packets only in broadcast mode. Figure 3-3 shows the packet format. The RIP-1 protocol packet does not carry any mask, so it can identify only the routes of the natural network segment such as Class A, Class B, and Class C, and does not support route aggregation or discontinuous subnet.

RIP version 2 (RIP-2), is a classless routing protocol. Figure 3-4 shows the packet format.

Figure 3-3 RIP-1 packet format

Figure 3-4 RIP-2 packet format

Compared with RIP-1, RIP-2 has the following advantages:

  • Supports route tag and can flexibly control routes on the basis of the tag in the routing policy.

  • Has packets that contain mask information and support route summarization and Classless Inter-Domain Routing (CIDR).

  • Supports the next hop address and can select the optimal next hop address in the broadcast network.

  • Supports sending update packets in multicast mode. Only RIP-2 routers can receive protocol packets. This reduces resource consumption.

  • Provides packets authentication to enhance security.

RIP-2 Route Summarization

When different subnet routes in the same natural network segment are transmitted to other network segments, these routes are summarized into one route of the same segment. This process is called route summarization.

RIP-1 packets do not carry mask information, so RIP-1 can advertise only the routes with natural masks. Because RIP-2 packets carry mask information, RIP-2 supports subnetting. RIP-2 route summarization improves extensibility and efficiency and minimizes the routing table size of a large-sized network.

Route summarization is classified into two types:

  • RIP process-based classful summarization

    Summarized routes are advertised using nature masks. For example, route 10.1.1.0/24 (metric=2) and route 10.1.2.0/24 (metric=3) are summarized as a route 10.0.0.0/8 (metric=2) in the natural network segment. RIP-2 supports classful summarization to obtain the optimal metric.

  • Interface-based summarization

    A user can specify a summarized address. For example, a route 10.1.0.0/16 (metric=2) can be configured on the interface as a summarized route of route 10.1.1.0/24 (metric=2) and route 10.1.2.0/24 (metric=3).

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034072

Views: 109465

Downloads: 155

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next