Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking Information About TE
Context
To check TE information during routine maintenance, run the following display commands in any view.
Procedure
- Run the display default-parameter mpls te management command to check default parameters of MPLS TE management.
- Run the display mpls te tunnel statistics or display mpls lsp statistics command to check tunnel statistics.
- Run the display mpls te tunnel-interface last-error [ tunnel-name ] command to check information about tunnel faults.
- Run the display mpls te tunnel-interface failed command to check MPLS TE tunnels that fail to be established or are being established.
- Run the display mpls te tunnel-interface traffic-state [ tunnel-name ] command to check traffic on the tunnel interface of the local node.
- Run the display mpls rsvp-te statistics { global | interface [ interface-type interface-number ] } command to check RSVP-TE statistics.
- Run the display mpls rsvp-te statistics fast-reroute command to check TE FRR statistics.