No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Reliability

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides guidance for configuring reliability services, including interface backup, BFD, VRRP, and EFM.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VRRP in Active/Standby Mode

VRRP in Active/Standby Mode

Active/Standby is the basic VRRP working mode, as shown in Figure 7-4. In active/standby mode, a virtual router consists of one master and multiple backups.

RouterA is the master and forwards service packets. RouterB and RouterC are backups and do not forward service packets. RouterA periodically sends VRRP Advertisement packets to RouterB and RouterC, notifying other switches that RouterA is working properly. If RouterA is faulty, a new master is selected from RouterB and RouterC based on their priorities. The new master then takes over traffic.

After RouterA recovers, it becomes the master in preemption mode. In non-preemption mode, RouterA remains in Backup state.

Figure 7-4  VRRP in active/standby
Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100034076

Views: 57776

Downloads: 107

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next