No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Reliability

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides guidance for configuring reliability services, including interface backup, BFD, VRRP, and EFM.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Association Between Interface Backup in Active/Standby Mode and NQA

Association Between Interface Backup in Active/Standby Mode and NQA

When the upstream indirectly connected link of the primary interface is faulty, the interface backup module cannot detect the fault, causing service interruption. The NQA technology measures network performance and collects statistics on the response time, jitter, and packet loss ratio. Association between interface backup and NQA enables the system to detect connectivity of the primary link and implement rapid switching when the primary link is faulty. This improves reliability of service transmission.

Figure 2-5  Networking diagram of association between interface backup and NQA

As shown in Figure 2-5, the egress gateway RouterA in the headquarters of company connects to the Internet through GE1/0/0. The link between GE1/0/0 and the Internet is used as the primary link, and the link between ATM0/0/0 (ADSL interface) and the Internet is used as the backup link. An NQA test instance is configured on RouterA and association between interface backup and NQA is configured on ATM0/0/0. When the link between RouterD and RouterB is faulty, the NQA test instance can detect faults and instructs RouterA to start ATM0/0/0 to transmit services.

Updated: 2019-08-12

Document ID: EDOC1100034076

Views: 65239

Downloads: 114

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next